Before & After Photos

For this project, we installed a 27" x 45" In-Swing Egress Window with a 24" deep Cascade Large Egress Well.

For this basement repair, we had to install 2 PowerBraces. PowerBraces were needed due to the fact that  one part of the foundation wall was bowing inward and we needed to stop that forward movement.

This install consisted of a Cleanspace Vapor Barrier, Waterguard and a SuperSump Pump with Battery Backup. The CleanSpace will direct any water that the customer had coming in through their block foundation, down to the waterguard, which will then flow the water over to the SuperSump and pumped out of the basement. Our SuperSump Pump has a high end 1/3 hp Zoeller cast iron pump that pumps out over 2600 gallons per hour and when paired with our UltraSump Battery Back Up, this customer's basement will stay dry during any power outages.

This customer had a slight bow in their block foundation, which caused a  horizontal crack to develop. We sent our inspector out to the property and the best solution for this customer scenario was to install our Carbon Armor straps with Armor Locks.

The Carbon Armor Wall Stabilization system works by fusing our Carbon Armor Straps to ArmorLock strips that are anchored to heavy steel brackets that are attached to the rim joist. This system will immediately stabilize your foundation wall and stop any further inward movement.

This customer had a very damp and humid crawlspace that was causing mold to grow and the current insulation to fall down. To start off this project we first removed all the old damp insulation and then treated the mold with our Mold-X2 treatment. Next, we installed our SilverGlo insulation wall panels and sprayed our spray foam insulation. Following our insulation install, we put down our CleanSpace Vapor Barrier, install a SmartPump with Smart Pipe and then we finish up the install with a SaniDry Sedona Dehumidifier.