Quantcast

Before & After Photos

Click on a photo to enlarge.

Front Concrete Sidewalk Repaired in Wall Township, NJ

A homeowner in Wall Township, NJ noticed their concrete sidewalk was sinking and settling. To eliminate this trip hazard, they called Quality 1st Basement Systems for a permanent solution. We used our PolyLevel Injections to bring the concrete back towards its original level. Check out the transformation! 

Concrete Driveway Repair in Wall, NJ

Quality 1st Basement Systems was hired to repair this sinking and settling concrete driveway in Wall, NJ. Concrete Repair Specialist, Joseph, recommended Polylevel, as the perfect solution. Concrete settles over time due to the lack of support from the soil underneath the slab. When soil becomes too wet or too dry, it causes movement for the concrete slab. Voids are created between the concrete slab and soil. PolyLevel fills those voids and permanently lift, levels and stabilizes the concrete area. 

Wall Township, NJ Pool Patio Repair

This Wall Township, NJ homeowner reached out to us after observing the initial signs of concrete settlement located around their backyard pool patio. After our system design specialist Jeffrey conducted a free-estimate inspection, we were able to supply the owner with an efficient solution. Our foreman Ash began administering our heavy-duty PolyLevel Foam Injections beneath the sunken slabs, to lift and entirely restore them to their designated surface level. This walkway has been completely strengthened and repaired, providing this owner with much-needed peace of mind!

Pool Deck Fixed in Normandy Beach, NJ

A pool in Normandy Beach, NJ had a sinking deck that needed to be repaired. Quality 1st Basement Systems injected PolyLEVEL and raised the concrete slab back into its position!

Normandy Beach, NJ Pool Patio is Leveled

This beautiful Normandy Beach Patio was experiencing some sinking concrete slabs around the pool area, causing some of the slabs to separate. The homeowner contacted Quality 1st Basement Systems when finding out that the slabs could simply be raised and then sealed without having to replace the entire slab! PolyLevel was pumped into the slab, raising it up to level and then Joint Seal was applied to fill all the voids. 

Our Products
Finishing Ideas
About
Learning Center
Become a Dealer
Free Estimate